Fiocchi Reloading Data Suggestions For Where To Look For Load To Reload These Low

Data has been obtained using 3 mm shots (u.s. 20 grains of clays is where you want. All [oz] weights are indicative.

Cheddite Reloading Data 410 Gauge

2 3/4 fiocchi plastic target shells reloading data with 44 loads. Reloading data shotgun 12/76 (3”) With weights of 1 3/8 ounces,1 1/2 ounces,1 5/8 ounces,1 7/8 ounces.

• Timothy Treadwells Wilderness Odyssey A Tale Of Natures Embrace
• Exploring The Simon Cowell Tragedy A Deep Dive Into His Life And Challenges
• Exploring Adam Scotts Iconic Role In Ratatouille A Deep Dive Into His Character And Influence
• Jadiann Thompson A Prominent Broadcast Journalist
• Intriguing Cast Of Cloverfield Unmasking Their Roles And Impact

With weights of 7/8 ounce,7/8 ounce.

I've loaded and shot them with your components and fiocchi hulls. Target hull loads reloading data with 8 loads. 3 fiocchi reloading data with 2 loads. 3 fiocchi plastic shells reloading data with 19 loads.

What are some of the best reloading manuals everyones using? Sure works a lot better and saves a reloader from buying stuff that it turns out there is very little load data for. 17 rows 2 3/4 fiocchi u.s. With weights of 7/8 ounce,1 ounce,1 1/8 ounces.

Cheddite Reloading Data 410 Gauge

With weights of 7/8 ounce,1 ounce,1 1/8 ounces.

Velocity has been measured using light gate digital sensors at a distance of 2,5 m from muzzle acc. If your advice is 100% valid, load some shells using fiocchi 616 primers using the following data intended for winchester w209 primers: With weights of 1 ounce,1 1/8 ounces. Here is some data that i just got back from precision reloading for comparison.

There's probably a million possible combinations of. From what i have read feds,fio's and chedd's the data can be used interchangeably. Do not use the fiocchi magnum primer in load data that specifies the. 107 rows 2 3/4 fiocchi shells reloading data with 53 loads.

View topic Fiocchi hull load data

Above data has been obtained using a 28 test barrel.

I’m looking to load 1 3/8 #5’s w fiocchi 616 primers, fiocchi hulls, and blue dot powder, i just need a wad that. This hull utilizes the fiocchi “magnum” primer, which is not the same as the fiocchi 616 primer. 5) with loads measured in [g]. I had tested some of my own loads and found that i was getting significantly higher velocities.

LeadFree Pistol Primers American Handgunner

Suggestions for where to look for load data to reload these fiocchi low